Hot Applied Shrinkable Tape

The specification of the tape consists of three layers,
Adhesive: butyl rubber based hot melt adhesive
Film backing: Radiation crosslinked polyethylene
Interleaf:Anti adhesive Film Treated with Silicone

After heating, formed corrosion protection seal
Strong backing provides outstanding waterproofing effect
High chemical resistance. resists impact, abrasion and ultraviolet light.
Excellent resistance against cathodic disbondment, dielectric breakdown.
Simple Application
Product Data Sheet Total Thickness:40mil, 50 mil, 60 mil , 65 mils.
Width:50, 100, 150, 300, 400, 500, 800 mm
Length: 10 m
Tensile Strength:35 N/cm
Elongation:400%
Adhesion Strength to pipe:30 N/cm
Application temperature: -10 -60 ℃
Temperature resistance:-50 ℃ - 80℃
Shelf Life: 12 months

No Special skills, equipments, patch closure nor primer are needed. Its superior flexibility provides easy and reliable application for irregular configurations of fittings, bends and elbows and small diameter of straight pipes.
Wrap spirally the tape over foreign matters-free and preheated surface, beginning at least 25~50mm (1~2 ) onto pipe coating. Wrap the tape with enough tension to obtain conformability and with minimum 50% of overlapping, while removing the release liner. Warm the end part of the tape and press down firmly. Using a torch, start at the edge of the tape and heat circumferentially around the coated pipe.
Finish off by heating over the entire tape vertically to ensure a uniform adhesion and by using a roller or gloved hands to remove wrinkle and air.